Product Code: N-9935

This product can be utilized on two components of the tire, treads or splices. Manufacturers spray or gravure apply a thin film of the cement to the underside of extruded treads and again on the splice (or skive) areas. An ideal replacement to liberally- applied solvent-based cements, high adhesion performance is achieved with a minimal amount of this product. When coated, the cured tread will show above average adhesion to most compounds, while leaving no air spaces/voids.

Ideal for retread manufacturers, N-9935 has proven long-term success and cost saving advantages when adhering new tread compound to salvaged tire carcasses.

When spray applying this cement, APV recommends a finely atomized air/fluid spray gun for optimum coverage and film thickness.
Our technical advice – whether verbal, in writing or by way of trials – is given in good faith but without warranty, and this also applies where proprietary rights of third parties are involved. It does not release you from the obligation to test the products supplied by us as to their suitability for the intended processes and uses. The application, use and processing of the products are beyond our control and, therefore, entirely your own responsibility. Should, in spite of this, liability be established for any damage, it will be limited to the value of the goods delivered by us and used by you. We will, of course, provide products of consistent quality within the scope of our General Conditions of Sale and Delivery.

Inquiry

Do you want to know more about Adhesives? Send us a message and we'll get back to you!

By sending this inquiry form, you accept our Terms and Conditions and our Privacy Policy.